Eolis 3D Wirefree IO
Eolis 3D Wirefree io wind detector
The Eolis 3D WireFree io continuously measures the oscillations of the sun protection caused by wind. If the set threshold value is exceeded, the sun protection is retracted for safety reasons. In this state, any manual or automatic movement command is blocked. If the set threshold value is not reached, an additional solar detector is triggered after 30 minutes. Manual control is possible again after 30 seconds.
Use with Somfy radio operators and receivers
Advantages:
• Reliable protection of the sun protection thanks to electronic recording of wind loads in three directions (3D effect)
• No cables required thanks to battery power supply
• Programming and mounting on the bottom rail in just a few minutes
• Simple adjustment through the selection of a predefined threshold value for oscillations or the specification of a manual oscillation
• “Auto on/off” function for programming and battery replacement. The sensor is only active in the mount
• Transmission of a message by the operator confirming successful connection when inserting the sensor into the mount
• Transmission of a message by the operator in case of low battery
• Available in 3 colors:
Technical data:
Operating voltage: 2 x 1.5 V DC
(AAA type batteries, no rechargeable batteries)
Operating temperature: -20 °C to +60 °C
Protection class: IP 44
Radio frequency: 868.25 MHz
Threshold value adjustment: 9 sensitivity levels Factory setting: threshold value 2
Dimensions (W x H x D): 153 x 25 x 38 mm
